yoke type track rollers

Features of yoke type track rollers

Support rollers are single or double row rolling bearings consisting of a thick-walled, usually crowned outer ring and cylindrical rolling elements (needles or cylindrical rollers). The outer rings generally have two fixed ribs, while the inner rings are usually ribless. In addition, the yoke type track rollers can be equipped with loose thrust washers. They can support high radial loads as well as low axial loads and are suitable for cam controls, guides and conveyor systems. The relubrication can be optionally via holes in the inner ring.

Load capacity

The permissible radial load Fr permissible of the back-up roller must not be exceeded, since the resulting pressures in contact can damage the mating track. About the values for the permissible radial load capacity of the back-up rollers, our service team will be happy to provide information.

The axial load capacity of cylindrical roller bearings is influenced by the design, the lubricant used and the bearing tilting. Loaded ribs or thrust washers must be supported over the entire height. The Fa/Fr ratio should not exceed 0.4. An exclusive axial load without radial load is not permissible.

For the minimum radial load of needle roller bearings, a ratio of Fr/Cr>0.02 is recommended, especially at high speeds. The values for the dynamic load rating Cr can be found in our product data sheets.

Accuracies

The dimensional and running tolerances of the stud type track rollers normally correspond to the tolerance class P0 according to DIN 620-2.

Bearing Clearance

The stud type track rollers are designed in the standard with the bearing clearance class C2 according to DIN 620-4.

Bore diameterC2CNC3C4
overtomin. [μm]max. [μm]min. [μm]max. [μm]min. [μm]max. [μm]min. [μm]max. [μm]
610072138231429
10180931811251833
182401052013282036
243011152013282341
304011162015332846
405011162318363051
506511582823433861
6580115103025514671
80100118123630

Sealing

Support rollers are usually designed with angle rings and abrasive sealing lip. Depending on the installation space, Sealing systems are also possible.

Materials

The back-up rollers are made in your standard version from material 1.3505 (100Cr6) and manufactured with a minimum hardness of 58 HRC. On request, corrosion protected versions are available.

Yoke type track roller (NUTR)
Yoke type track roller (PWTR)
Yoke type track roller load directions
Wälzlager Kontaktperson Platzhalter

Your contact person

  • Roler bearings
  • +49 (2053) 497 - 0
  • Opening hours
    Mo-Do.: 08:00-16:00
    Fr.: 08:00-14:45
  • Delivery times
    Mo-Do.: 06:00-13:30
    Fr.: 06:00-11:00
    oder nach Absprache